Amer-networks WS6028 Web GUI Bedienungsanleitung Seite 17
- Seite / 105
- Inhaltsverzeichnis
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
Basic Management Configuration Chapter 3 Fast Config
3-1
Chapter 3 Fast Config
Click “WLAN configuration->Fast Config” to configure the WLAN function quickly,
including WLAN managed IP address, AP groups and the basic network configuration;.
This configuration will then be sent to all connect AC in the network.
Notice: This fast config is used for the simple configuration or a quick start wizard. If
the AC has any previous configuration on it, it will be replaced with the fast config.
3.1 IP Config
To configure the management IP address for the AC. Input the wireless IP address to
be configured in the box and click the “submit” button. The input IP address will be
configured as the wireless IP address.
3.2 AP Group Config
The AP group config can add and update the ID and hardware type of the AP in the
group.
Example: Input 17 in the ID box, select 17- WAP33DC, Indoor Dual Radio a/n, b/g/n
as the corresponding AP hardware type; and then click “add” to add them into the table.
Click “submit” to submit them to AC.
Notice: Click the “submit” button, and the configuration will be applied on the AC. Any
modifications will be lost if the submit button is not selected.
- WS6028 Web GUI Manual 1
- Content 2
- CHAPTER 18 6
- CHAPTER 19 6
- Chapter 1 Web Management 8
- Fig 1-5 10
- 1.2.1 Login AC Switch 11
- Fig 1-7 12
- Fig 1-8 12
- 1.2.3 Menu Introduction 13
- Chapter 2 Dashboard 15
- 2.3 Device Info 16
- 2.4 Support 16
- Chapter 3 Fast Config 17
- 3.3 Network Config 18
- 3.3.1 SSID 18
- 3.3.2 Security 18
- 3.3.2.2 WPA/WPA2 19
- Chapter 4 System Config 20
- 4.3 AP Authentication Mode 21
- 4.4 AP Validation Method 21
- 4.6 Radius Accounting Mode 22
- 4.7 Radius Accounting Server 22
- 4.8 Client-QoS Global Mode 22
- 4.9 Country Code 22
- 4.10 Peer Group ID 23
- 4.11 Cluster Priority 23
- Chapter 5 Networks 24
- 5.2.3 WEP 802.1x 25
- 5.2.4 WPA Personal 26
- 5.2.5 WPA Enterprise 26
- 5.3 Configure VLAN 27
- 5.4 Mac Authentication 27
- 5.5 Enable Dist-tunnel Mode 28
- 5.6 Client QoS 28
- Chapter 6 AP Management 30
- 6.1.2 AP Config 31
- 6.1.3 Radio 31
- 6.1.4 VAP 32
- 6.1.5 QoS 33
- 6.1.6 TSPEC 34
- 6.2 Copy AP Group 34
- 6.3 Apply AP Group 35
- 7.1 Radius Configuration 36
- 7.1.1 Global Configuration 36
- Configuration 37
- 7.1.4 Radius Group Manage 37
- 7.1.5 Radius Configuration 38
- 7.2 LDAP Configuration 38
- Chapter 8 Discovery 40
- Chapter 9 Provisioning 42
- 9.2 Switch Provisioning 43
- 9.3 Mutual Authentication 43
- Chapter 10 WIDS Security 45
- 10.2 Client Configuration 46
- 10.3 Known Client 47
- Chapter 11 Captive Portal 49
- Chapter 12 Config Push 54
- 13.1 AP Image Auto Upgrade 56
- Chapter 14 Load Balance 60
- Identifier (OUI) 65
- Chapter 17 Trap and Syslog 66
- 17.1.2 Captive Portal 67
- 17.2 Syslog Configuration 67
- Chapter 18 Monitor 68
- 18.1.1.2 Cluster Controller 70
- 18.1.1.4 Global Statistics 71
- 18.1.1.6 TSPEC Status 71
- 18.1.1.7 TSPEC Statistics 71
- 18.1.2.1 AC Selection List 73
- 18.1.2.3 AC Statistics 74
- 18.1.2.4 TSPEC Status 74
- 18.1.2.5 TSPEC Statistics 74
- 18.2 AP 75
- 18.2.1 Basic AP Information 75
- 18.2.2 AP Detail 76
- 18.2.2.2 Radio Detail 77
- 18.2.2.3 Neighbor APs 77
- 18.2.2.4 Neighbor Clients 78
- 18.2.2.5 VAP 78
- 18.2.2.6 VAP TSPEC 78
- 18.2.3 Failure AP List 79
- 18.3 Wireless Client 79
- 18.3.3 Detected Client List 81
- 18.4 RF Scan 84
- 18.4.1 AP RF Scan Status 84
- 18.4.2 AP RF Scan Detail 84
- 18.4.2.1 AP RF Scan Status 85
- Chapter 19 Management 87
- 19.1.4 Basic Configuration 89
- 19.2 SNMP Configuration 91
- 19.2.1 SNMP Authentication 91
- 19.2.1.2 Groups 92
- 19.2.1.3 Views 93
- 19.2.2 SNMP Management 94
- 19.2.3 Community Managers 94
- 19.2.5 SNMP Statistics 95
- 19.3 SSH Management 96
- 19.3.1 Switch on-off SSH 96
- 19.3.2 SSH Management 96
- 19.4 Firmware Update 97
- 19.4.1 TFTP Client Service 98
- 19.4.2 TFTP Server Service 99
- 19.4.3 FTP Client Service 100
- 19.4.4 FTP Server Service 101
- 19.5.1 Telnet Server State 102
- Connection 102
- 19.6.1 Debug Command 103
- 19.6.2 Others 104
© 2020, manymanuals.de. Alle Rechte vorbehalten. | 0.054 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern